Bosch 1 687 011 538 Manual Del Usuario página 15

7. Pull the motor cable through the rear cover over the
terminals and fasten it to the power terminals U/T1,
V/T2, W/T3 and PE on the frequency inverter.
— Connect wire 1 to power terminal U/T1.
— Connect wire 2 to power terminal V/T2.
— Connect wire 3 to power terminal W/T3.
— Connect wire GN/YE to power terminal PE.
 13: Motor cable connection
8. Pull the connection cables of line choke L1
and (2) and the cable with the suppression
capacitor  14 (3) through the rear cover over the
terminals and connect it to the terminals P0 and
PA/+ on the frequency inverter.
— Connect wire 1 to power terminal P0.
— Connect wire 2 together with the cable with the
suppression capacitor to power terminal PA/+.
 14: Connecting cables
Robert Bosch GmbH
 15: Line choke L1 connection
9. Connect the voltage supply (3 cables with
suppression capacitors) to power terminals R/L1,
S/L2, T/L3 and PE on the frequency inverter as
follows:
From device / terminal
K1 / 1(L1)
K1 / 3(L2)
 14 (1)
K1 / 5(L3)
X1 / PE
 16: Power supply connection
10. Remove jumper JP1
11. Secure jumper JP1
(1) . To secure, use the lower slot on the actuator.
1 687 011 538 | 15 | en
To device / terminal
A11 / R/L1
A11 / S/L2
A11 / T/L3
A11 / PE
 17 (2).
 17 (2) with a cable tie
 17
1 689 978 635 | 2019-01-01