BOND MANUFACTURING 67513 Instrucciones De Montaje página 6

ASSEMBLY INSTRUCTIONS
* Please keep these owner's manual for future reference.
*If you have opened the carton and removed all packages, please disregard the STEP 1 and 2. See the STEP 3
directly.
STEP 1. (1) Open the carton and turn it upside down, make sure the 4
pieces of the carton being open up as below Figure STEP1.
(2) Lift off the carton carefully and be wary of the accessories inside
falling away.
(3) Take all the packing materials away except for the polyfoam
rounding the top of the firebowl. See Figure STEP 1.
A
STEP 3.
(I) Check each part before using the product. Make sure the gas supply
system is turned "OFF" before assembling. See Figure C.
(II) Open the storing door on the firebowl for the gas tank. Take away the box
containing lava rock. See Figure C.
(III) Put the gas tank in the metal stand. Make sure the gas tank sits on
the metal stand completely. Turn the wing screw on the outer part of
metal stand clockwise to secure the gas tank tightly. See Figure F.
(IV) Locate the battery, remove the plastic cover first. Unscrew the
rubber cap of the Electric Ignitor, place a AAA battery into the battery
case. Make sure the positive pole ("+") towards the cap. Screw the cap
back to the battery case tightly. See Figure D.
(V)
Place the lava rock averagely in the fire bowl on the top of the
irebowl. See Figure E.
** DO NOT COVER THE IGNITION SCREEN when
placing the lava rock into the fire bowl. Always keep
Ignition Screen visible.
** Connect the Pressure-Regulating Valve to the gas tank.
See Figure IV.
1) Turn the cylinder valve clockwise to close the gas supply
on the gas tank.
2) Screw Regulator Coupling clockwise by hand only. Make
sure it is fastened.
STEP 2. (1) Turn the firebowl heads up on a flat ground.
(2) Remove all the polyfoam rounding the top of the
firebowl.
See Figure STEP 2.
B
6