Murray LT155420 Manual De Instrucciones página 12

How to Prepare the Engine
NOTE: The engine was shipped from the factory filled
with oil. Check the level of the oil. Add oil as needed.
NOTE: The operation of a new engine will sometimes
result in a slight amount of smoke. This smoke is
caused by paint or oil on or around the muffler. This is
normal and only expected during initial operation.
A separate engine manual is also included with the
unit. See this engine manual for the manufacturer's
instructions for the type of gasoline and oil to use.
Before you use the unit, read the information on
safety, operation, maintenance, and storage.
WARNING: Follow the engine
manufacturer's instructions for the type of
gasoline and oil to use. Always use a safety
gasoline container. Do not smoke when
adding gasoline to the engine. When inside
an enclosure, do not fill with gasoline.
Before you add gasoline, stop the engine.
Let the engine cool for several minutes.
IMPORTANT: This unit is equipped with an internal
combustion engine and must not be used on or near
any unimproved forest-covered, brush-covered or
grass-covered land unless the engine's exhaust
system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark
arrester is used, it must be maintained in effective
working order by the operator.
In the State of California the above is required by law
(Section 4442 of the California Public Resources
Code). Other states may have similar laws. Federal
laws apply on federal lands. See an Authorized
Service Center for a spark arrester for the muffler.
In some areas, local law requires the use of a resistor
spark plug to control the ignition signals. See an
Authorized Service Center for a resistor spark plug for
the engine.
NOTE: Actual sustained horsepower will likely be
lower due to operating limitations and environmental
factors.
English
10 murray.com