Panasonic TY-ST58PF20 Instrucciones De Instalación página 19

Pedestal móvil para la pantalla de plasma
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 58
3. Fitting to the stand
Note
Before fitting the plasma display, make sure to lock the
casters.
Locking and unlocking the casters
Caster locked
Push the
bottom of
the lever
1. Fitting plasma display
Engage the upper insulation spacers of the
plasma display with the cutouts at the top of the
mobile stand, and slowly lower the plasma display
into place.
While lifting the plasma display slightly, insert the
bottom insulation spacers into the holes at the
lower end of the mobile stand, and then lower the
plasma display straight down into place.
CAUTION
If the plasma display is lifted too much, it will fall down
and personal injury may result.
2. Fixing of the plasma display
Firmly tighten the two screws for securing unit
the holes of the top bracket for plasma display
(Tightening torque: 1.5 to 2 N•m)
Note
Make sure to fit the screws for securing unit
and right to prevent the plasma display from coming off.
Caster unlocked
Push the
top of the
lever
on the left
A B
A B
Mark A: 58-inch
Mark B: 42/50-inch
Holes for screws for securing unit
(Use screw holes above cutouts
in
with insulation spacers inserted)
.
Screw for securing unit
B A
B A
Upper insulation spacer
Cutout at top
Lower
insulation
spacer
Hole at bottom
19

Publicidad

Tabla de contenido
loading

Tabla de contenido