Kreg Micro-Pocket KPHA730 El Manual Del Propietario página 6

2
Position your Workpiece
There are two different methods for aligning your Kreg Jig with your workpiece:
■
For a workpiece narrower than 1-1/4" wide it is recommended to place
each pocket hole 3/8" from the edge, if possible. To do this, mark 3/8" from
each edge as the center of the pocket hole and align one of the numbered
pocket-hole drill guides (number 1, 2, or 3) and drill the first pocket hole.
Then, re-position to the second mark and repeat the drilling process.
■
For a workpiece between 1-1/4" to 2-1/4", use the board centering mark A
and drilling pocket-holes 1 and 2.
■
For a workpiece between 2-1/4" and 3-1/2", use board centering mark B
and drilling pocket-holes 1, 2, and 3.
■
For wider workpieces such as a drawer box side, it is recommended
that the pocket-holes be spaced at 3/4" center-to-center spacing. For
workpieces such as panels, it is recommended that the pocket-hole
spacing be 1/2" to 1-1/4" from the edge and then every 4" to 6".
1
1-1/4" to 2-1/4"
1-1/4" to 2-1/4"
2-1/4" to 3-1/2"
Press down on the jig handle in one smooth motion until the jig handle is at
its travel limit. Proceed to the Operation - Drilling and Driving Pocket-Hole
Screws section to start drilling.
6
2 3
Board Width
A
Center Mark
A
C
B
B C
Drill Guide
1 and 2
2 and 3
1, 2, and 3