Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Front
Passenger side shown
Repeat for opposite side
Adjust bracket so that hole in channel bracket
lines up with hole in pinch weld. Insert flange bolt
through hole in channel bracket and thread into nut
on pinch weld. Bolt should be finger tightened. Repeat
bolt installation for each bracket assembly.
4
Install running board to brackets using hardware
provided in board kit. Refer to board installation sheet
for specific instructions.
Tighten bracket hardware after board has been
installed.
Repeat board installation for opposite side of vehicle.
Front
Passenger side shown
3
12
PAGE
OF
10394
Rev C
Publicidad
