Troubleshooting - BALDR B0389WST4H4-V3 Manual De Usuario

TROUBLE SHOOTING
Problem
Outdoor reading is
flashing or showing
dashes
No outdoor sensor
reception
Inaccurate
temperature/
humidity
Possible Solution
Flashing of the outdoor reading is generally an
indication of wireless interference.
1. Bring both the sensor and display indoors, side
by side and remove batteries from each.
2. Make sure the 1-2-3 switch on both units match.
3. Reload batteries in outdoor sensor.
4. Reload batteries in main unit.
5. Let both units sit within a couple feet of each
other for a few minutes to gain a strong connection
before taking sensor to outdoor area.
1.Reload the batteries of both outdoor sensor and
main unit. Please refer to the SENSOR SETUP
section.
2.Relocate the main unit and/or the outdoor sensor.
The units must be within 100m(328ft) of each other.
3.Make sure both units are placed at least 0.9 m
(3 ft) away from electronics that may interfere with
the wireless communication (such as TVs,
microwaves, computers, etc).
4.Use standard alkaline batteries. Do not use heavy
duty or rechargeable batteries. NOTE: It may take
a few minutes for main unit and sensor to
synchronize after batteries are reloaded.
1.Place the whole set device at the same position
for half an hour after power on.
2.Place the main unit and sensor horizontally,
meanwhile ,Please place the sensor at a height
of 2-2.5 meters above the ground.
3.Make sure both the main unit and sensor are
placed out of direct sunlight and away from any
heat sources or vents.
12