Bushnell ImageView 11-8200 Manual Del Usuario página 9

this mode until you change it, or until the camera's memory is full. This is indicated by the
display showing "FUL" and a beep alarm.
• High/Low Quality (LQ) : When "LQ" is displayed, pressing "OK" will set the camera to low
resolution mode (320x240 pixels)-the "LQ" icon will stop blinking. LQ mode will allow you
to fit more photos in the memory before you stop to download them, with the tradeoff of
less quality per photo. To reset the camera to high resolution, return to the LQ mode, and
press SNAP again ("LQ" will no longer be displayed). When the LQ icon is off, the camera
is in high resolution mode (640x480 pixels) for best quality.
) : This mode sets the camera to take short movie clips (.avi files) rather than
• AVI Mode: (
still photos. After this mode has been activated (press SNAP when the movie icon blinks),
holding down the SNAP button will film an avi movie until you release it (or the memory
is full). When the SNAP button is released, the camera reverts back to normal still photo
operation (assuming unused memory remains). Repeat the steps to set AVI mode again if
you wish to shoot more movie clips.
• Power Frequency Setting: (60/50 Hz): This sets the correct electrical frequency to avoid any
"flickering" in the camera's output. The normal default is "60" Hz (cycle), as used in the
United States. If you are using the camera in a country with 50 Hz power frequency, press
SNAP when the "50" icon blinks to select it.
) : Pressing SNAP when the "Delete Last" icon is blinking will delete (erase)
• Delete Last (
the last photo you took from the camera's memory.
3