Installation; Dimensions (Mm) - Klarstein DELICATESSA 3 Manual Del Usuario

EN
38

INSTALLATION

Cut out the work surface according to the sizes shown in the table and the drawing.
For the purpose of installation and use, a minimum of 50 mm space shall be preserved
around the hole. Be sure the thickness of the work surface is at least 30 mm. Please
select heat-resistant work surface material to avoid larger deformation caused by the
heat radiation from the hotplate.
Dimensions L
(mm)
10030683 288
10034193
590
10034194
10036334 450
Installation of the foam gasket
Do not install the hob without the foam gasket. The gasket should be fitted to the hob as
follows:
• Remove the protective film from the gasket.
• Then attach the gasket to the bottom of the glass next to the edge.
• The gasket must be fitted along the entire length of the edge of the glass and must
not overlap at the corners.
• When fitting the gasket, ensure that the glass does not come into contact with sharp
objects.
W H D
520 52 48
520 56 52
520 52 48
Gasket
A B
265+5 495+5 min. 50
555+5 495+5 min. 50
430+5 495+5 min. 50
X