If you have questions about this product, call our technical support line at
1-800-345-7669, or write to:
Sony Computer Entertainment America
Consumer Services/Technical Support
PO Box 5888, San Mateo, CA 94402-0888 U.S.A.
Declaration of Conformity
Trade Name :
SONY
Model No. :
SCPH-70011
SCPH-70012
Responsible Party :
Sony Electronics Inc.
Address :
16450 W. Bernardo Dr. San Diego, CA 92127 U.S.A.
Telephone No. :
858-942-2230
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
You are cautioned that any changes or modifications not expressly approved in this
manual could void your authority to operate this equipment.
This equipment complies with Part 68 of the FCC rules and the requirements adopted
by the ACTA. On the bottom surface of the console (when placed in the horizontal
position) is a label that contains, among other information, a product identifier in the
format US:AAAEQ##TXXXX. If requested, this number must be provided to the
telephone company.
The Ringer Equivalence Number (REN) is used to determine the number of devices
that may be connected to a telephone line. Excessive RENs on a telephone line may
result in the devices not ringing in response to an incoming call. In most but not all
areas, the sum of the should not exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by the total RENs, contact the
local telephone company. For products approved after July 23, 2001, the REN for
this product is part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal
point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on
the label.
A jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements adopted by the
ACTA.
This product uses the "RJ-11C" telephone jack.
If this equipment causes harm to the telephone network, the telephone company will,
when practical, notify you in advance that temporary discontinuance of service may
be required. If advance notice is not practical, the telephone company will notify you
as soon as possible. Also, you will be advised of your right to file a complaint with
the FCC if you believe it is necessary.
The telephone company may make changes to its facilities, equipment, operations or
procedures that could affect the operation of equipment. If this happens, the
telephone company will provide advance notice so you can make the necessary
modifications to maintain uninterrupted service.
If you have questions about this product, call our technical support line at
1-800-345-7669, or write to:
Sony Computer Entertainment America
Consumer Services/Technical Support
PO Box 5888, San Mateo, CA 94402-0888 U.S.A.
This equipment cannot be used on telephone company provided coin service.
Connection to party line service is subject to state tariffs.
Repair of this product should be made only by an authorized Sony Service Center.
For the Sony Service Center nearest you, call 1-800-345-7669.
Telephone Consumer Protection Act of 1991
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person
to use a computer or other electronic device to send any message via a telephone
facsimile machine unless such message clearly contains, in a margin at the top or
bottom of each transmitted page or on the first page of the transmission, the date and
time it is sent and an identification of the business, other entity, or individual sending
the message, and the telephone number of the sending machine or such business,
other entity, or individual. In order to program this information into your facsimile
machine, see your facsimile software documentation.
US
US
WARNINGS
3