Kohler K-307 Manual Del Usuario página 4

Washers
Screws
Wall Plate
3. Install the Mixer
Attach the mixer to the wall plate with the screws and washers
provided.
Tighten the screws securely.
Install 1/2" hot and cold supply piping to the mixer valve.
Temporarily pull the plaster guards from the handle and spout
shanks. Do not discard them at this time.
Position a bucket in front of the spout shank, and turn on the
water supplies to the mixer valve.
Slowly open the mixer valve stems, and allow the hot and cold
water to flow from the spout shank for about a minute.
Close the valve, and carefully inspect all connections for leakage.
Repair if necessary.
Turn off the water supplies. Open the valve stem to relieve the
water pressure.
Reattach the plaster guards to the handle and spout shanks.
1015917-2-D
Mixer
1/2" Hot
Supply
4
Handle
Assembly
Setscrew
Plaster
Guards
1/2" Cold
Supply
Kohler Co.