Installation Of The Unit - Mestra MULHACEN R-080093 Manual Del Usuario

Recortadora de modelos con freno
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
The R-080093/R-080095 is an easy to handle
model trimmer specially designed for the field of
dental prosthesis.
Its 3000 r.p.m. powerful motor has a brake that
stops the spin after turning the main switch off.
Its dimensions give the unit an excellent stability
during operation. It features a 122 mm window (one
of the widest in the market).
Its design allows to place a big storage tray
(R-100062) on the unit in order to keep the models
well arranged and the workbench clear.
The R-080095 has a factory installed diamond disc.
The R-080093 has a factory installed 80 grit
abrasive disc.
With the R-080093, besides you will receive two
additional sample discs (grain 80 and 120)
Replacements:
80 grit abrasive disc (coarse) R-080093-04 (5 u.)
120 grit abrasive disc (fine)
Diamond disc
The following items are also factory supplied:
-
A water inlet hose.
-
An extensible drainpipe.
-
An Allen spanner to dismount the plate.
-
A bolt to dismount the plate.

INSTALLATION OF THE UNIT

1. Carefully unpack the model trimmer. Make sure
the unit has not suffered any damage during
the transport.
2. Place the unit on a flat and firm surface, away
from any heat or vibration source. The place
8
GB
R-080093-05 (5 u.)
R-080093-55 (1 u.)
has to be close to a water source with a
threaded connection and to a drainpipe.
3. Connect the bent end of the flexible hose to the
fitting placed at the rear of the unit. Connect the
other end to the water inlet. To do this, insert
the threaded tap connector at the end of the
hose into the tap.
4. Connect the water outlet hose into the water
outlet (H) in the right bottom front part of the
unit. Connect the other end of the hose to a
drainpipe. Place the hose with a certain slope,
to prevent the water flow to stop and to ease
the drainage.
5. For an optimum operation of the unit Talleres
Mestraitúa, S.L. strongly recommends to use
the R-080085 plaster decanter.
6. The unit has four rubber pads. When designing
the unit, special care has been taken to give the
unit enough weight and robustness to prevent
any
movement
additional fixing element is needed.
7. Connect the unit to a proper grounded power
source.
8. Make sure that the disc cleaning system works
properly. To do this, turn on the main switch in
the upper part of the unit. The trimmer will start
up and the electro-valve that monitors the inlet
water flow will open.
9. Then open the water stopcock and select the
desired flow by means of the tap knob of the
trimmer. After a few minutes of operation, make
sure there is no leak in the pipe and hose
connections.
OPERATION OF THE UNIT
1. Adjust the table (B) with the knob (E), according
to the type of work. Once the working position
has been selected, screw the locknut (C) up as
far as it goes to fix the table.
2. If you want to trim at a vertical 90º angle, align
the lower edge of the table with the edge of the
casing:
during
its
operation.
90º
No

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mulhacen r-080095

Tabla de contenido