Worx WG650 Manual De Instrucciones página 10

avoid accidental starting - Don't carry
8)
plugged-in Snow Thrower with finger
on switch. be sure switch is off when
plugging in.
9) if cord is damaged in any manner while
plugged in, pull extension cord from wall
receptacle.
10) don't abuse cord - Never carry Snow
Thrower by cord or yank it to disconnect
from receptacle. Keep cord from heat, oil,
and sharp edges.
11) Keep hands away from moving parts.
12) Keep guards in place and in working order.
13) don't force Snow thrower - it will
perform better and safer at the rate for
which it was designed.
14) don't overreach - Keep proper footing
and balance at all times.
15) if the Snow Thrower strikes a foreign
object follow these steps:
i) Stop Snow Thrower. Release the switch.
ii) inspect for damage.
iii) Repair any damage before restarting
and operating the Snow Thrower.
iv) Unplug power cord.
16) disconnect Snow thrower -
Disconnect the appliance from the power
supply when not in use, before servicing,
10
when changing accessories such as
blades, and the like.
17) Store idle Snow thrower indoors -
When not in use, appliances should be
stored indoors in dry, and high or locked-
up place -out of reach of children.
18) maintain Snow thrower with care
- Follow instructions for lubricating and
changing accessories.
SaFE oPEratioN PracticES For
waLk-bEhiNd SNow throwEr
traiNiNg
1. Read the operating and service instruction
manual carefully. be thoroughly familiar
with the controls and the proper use of the
equipment. Know how to stop the unit and
disengage the controls quickly.
2. Never allow children to operate the
equipment. Never allow adults to operate
the equipment without proper instruction.
3. Keep the area of operation clear of all
persons, particularly small children, and pets.
Snow thrower
4. exercise caution to avoid slipping or falling,
especially when operating in reverse.
PrEParatioN
1. Thoroughly inspect the area where the
equipment is to be used and remove all
doormats, sleds, boards, wires, and other
foreign objects.
2. Do not operate the equipment without
wearing adequate winter outer garments.
Wear footwear that will improve footing on
slippery surfaces.
3. Use extension cords and receptacles
as specified by the manufacturer for all
units with electric drive motors or electric
starting motors.
4. Adjust the collector housing height to clear
gravel or crushed rock surface.
5. Never attempt to make any adjustments
while the motor is running (except
when specifically recommended by
manufacturer).
6. Let motor and machine adjust to outdoor
temperatures before starting to clear snow.
7 . Always wear safety glasses or eye shields
during operation or while performing an
adjustment or repair to protect eyes from
foreign objects that may be thrown from
the machine.
oPEratioN
1. Do not put hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all times.
2. exercise extreme caution when operating
on or crossing gravel drives, walks, or
roads. Stay alert for hidden hazards or
traffic.
3. After striking a foreign object, stop the
motor, disconnect the cord on electric
motors, thoroughly inspect the Snow
Thrower for any damage, and repair the
damage before restarting and operating
the Snow Thrower.
4. if the unit should start to vibrate
abnormally, stop the motor and check
immediately for the cause. Vibration is
generally a warning of trouble.
5. Stop the motor whenever you leave the
operating position, before unclogging the
auger housing or discharge guide, and
en