Kenmore 146.10016510 Manual De Uso Y Cuidado página 28

Sideburner
11
□ Remove the sideburner grate. Loosen the burner in the sideburner shelf (B). To loosen, unscrew and
remove two front screws holding sideburner in place. (A). Note: Do not loosen electrode screw.
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□ Insert valve stem through hole in fascia. (D) Attach bezel to fascia and valve face with
previously removed 2 screws. Attach bezel with black mark facing up (E).
□ Place sideburner tube over the valve, making sure that valve is inside sideburner tube.(F)
□ Push control knob onto sideburner valve stem. (G)
□ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace
sideburner grate. (H)
□ Connect both igniter wires to the igniter module on the inside of the right fascia. To
connect, push igniter wire tips onto pins in igniter module.(I)
□ Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack)
into battery slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)
A
A
C
C
E
28 • 146.10016510
B
B
D
D
F
F