Fein ALG80 Manual De Instrucciones página 10

en
10
Remove the battery from the charger
and pull the mains plug when not
using for extended periods. Saving
energy helps to save the environ-
ment.
When cleaning the battery charger,
pull the mains plug out of the socket.
There is danger of electric shock.
Do not rivet or screw any name-
plates or signs onto the battery
charger. If the insulation is damaged,
protection against an electric shock
will be ineffective. Adhesive labels
are recommended.
Charge only intact original FEIN bat-
teries that are intended for your
power tool. When charging incor-
rect, damaged, repaired or recondi-
tioned batteries, imitations or other
brands, there is danger of fire and/or
explosion.
Caution! Using the charger with Blue-
®
tooth may cause interference with
other devices and systems, aircraft
and medical devices (e.g., cardiac
pacemakers, hearing aids). Also, the
possibility of humans and animals in
direct vicinity being harmed cannot
be completely exempt. Do not use
the charger with Bluetooth
medical devices, chemical plants,
areas with explosion hazards (e.g.
petrol stations), in blasting areas and
in aircraft. Avoid operation in direct
vicinity of the body over longer peri-
ods.
®
The Bluetooth
are registered trademarks of the
Bluetooth SIG, Inc. The use of this
word mark and the logos by C. & E.
Fein GmbH is under license.
®
near
word mark and logos
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
acceptany interference received,
including interference that may cause
undesired operation.
Caution: The user is cautioned that
changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
Note: This equipment has been
tested and found to comply with the
limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harm-
ful interference in a rezidential instal-
lation. This equipment generates
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However,
there is no guarantee that interfer-
ence will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equip-
ment off and on, the user is encour-
aged to try to correct the
interference by one or more of the
following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between
the equipment and receiver.