Standard Equipment; Machine Assembly; Mounting On 1206 Stand - RIDGID 300 Power Drive Manual De Instrucciones

Geared Threaders:
Pipe 2
Chuck ............................Speed Grip Chuck with
Replaceable Jaw Inserts
Rear Centering Device....Cam Action Rotates with
Chuck
Operating Speed ............38 RPM or 57 RPM
Motor:
Type ............................Universal
Horsepower................. 1
Volts ............................120V Single Phase AC
25-60 Hz
(230V Available On Request)
Amps...........................15 Amps (36 RPM)
18 Amps (57 RPM)
Controls .........................FOR/OFF/REV Switch and
ON/OFF Foot Switch
Weight (machine only) ....87 lbs. (39.5 kg)
Figure 2 – No. 300 Power Drive and No. 1206 Stand

Standard equipment

Power Drive Only:
• 300 Power Drive
940-600.015.10_REV. D
1 / " through 6"
2
/ HP
2
300 Power Drive
Power Drive Complete:
• 300 Power Drive
• 1206 Stand
• 311 Carriage with Lever
• 341 Reamer
• 360 Cutter
• 811A Universal Die Head
• Set 1 / " – 3 / " Universal Alloy Dies
2 4
• Set 1" – 2" Universal Alloy Dies
• 4 oz. Can White Sealant w/PTFE
• 418 Oiler
• 1 Gallon Nu-Clear Thread Cutting Oil
• 32 Transporter
Catalog Model
No. No. Description
41855 300 Only 115V,25-60 Hz
75075 300 Only 115V,25-60 Hz
41860 300 Only 230V,25-60 Hz
75435 300 Only 230V,25-60 Hz
15682 300 115V,25-60 Hz
Complete 1/2" – 2" NPT
15722 300 115V,25-60 Hz
Complete 1/2" – 2" NPT

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Power Drive is required. Failure to mount the
Power Drive to a stable stand or bench may result
in tipping and serious injury. The following proce-
dures should be followed:
Mounting on No. 1206 Stand
1. Set up the 1206 Stand by opening legs and pushing
down on the tray. Legs should be stiff and the stand
should not wobble.
NOTE! The tristand leg stiffness can be increased or
decreased by the following procedure:
• Place stand upside down on a flat surface.
• Unlock tray so legs are loose.
• Locate the set screw on the tray leg support on the
rear leg (Figure 3).
Spindle Weight
Speed
RPM Lb. Kg.
38 94 43.0
57 94 43.0
38 94 43.0
38 94 43.0
38 212 96.2
57 212 96.2
5