Safety Instructions - HumanTechnik signolux Guia De Inicio Rapido

We would like to congratulate you on purchasing the »signolux«
alerting system! You have chosen modern and reliable devices.
Kindly read the user manual carefully in order to use the device
properly and to familiarise yourself with all the possibilities this
system offers.
Package contents
Please check if all following parts are included:
- Doorbell-pushbutton
- Battery (CR2032)
- Double-sided adhesive strip
- User manual
- Warranty card
Should any parts be missing, kindly contact your specialist dea-
ler or the manufacturer directly.

Safety instructions

- Prior to putting the device into operation and using it, kindly
read this manual thoroughly and in full.
- Store this operating manual in a safe place so that it is also
accessible for other users at any time.
- When using power tools always follow the instructions of
the manufacturer and wear suitable protective equipment
(e.g. protective goggles).
- Kindly check before starting to drill if there are any hidden
electric cables and water pipes in the walls. In case of
doubt we recommend using a a cable detector.
Functioning principle
A »signolux« alerting system consists of at least one trans-
mitter (e.g. doorbell pushbutton) and a »signolux« receiver.
Up to 8 transmitters can be assigned to each event icon of
the receivers.
If e.g. the doorbell pushbutton is pressed, a radio signal
(868,35 MHz radio frequency) is transmitted to the »signolux«
receiver. Depending on the receiver type, the received
signals are indicated with light, sound or vibration.
Setup
1. Inserting and replacing the battery
In order to be able to insert the coin cell battery (type CR 2032)
you first have to open the battery compartment.
a) Place the doorbell pushbutton in such a way on the work
surface that the pivots of the transparent plastic face
are at the rear (fig. 1 A and C).
A
Figure 1: Doorbell-pushbutton
C
B
English 4