Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
CT50A, CT51A, CT53A
Thermostats
CT50A Heating only
Compatible with most 2 wire gas and oil heating systems.
CT51A Heating/Cooling
Compatible with most 4 wire gas and oil heating systems
and electric heat. Will not work on Heat Pump systems.
CT53A Millivolt heating only
For 250, 500, 750 millivolt systems.
PREPARATION FOR INSTALLATION
Assemble tools required; screwdriver, level, wire stripper.
REMOVING OLD THERMOSTAT
! Begin by turning off power to the heating system at
the main fuse panel. Most residential systems have a
separate switch box or circuit breaker for
disconnecting power to the furnace.
! Remove cover of old thermostat. Cover normally
snaps off when pulled firmly from the bottom. If it
resists, check for a screw that locks the cover on.
CT51A
INSTALLATION INSTRUCTIONS
MERCURY NOTICE
If this product is replacing a control that contains
mercury in a sealed tube, do not place the old
control in the trash. Contact your local waste
management authority for instructions regarding
recycling and proper disposal.
For CT50A, CT51A Installation
! Before removing the old thermostat from the wall, look
at it carefully to locate the heat anticipator adjustment
mechanism. See illustration below to help you
recognize the heat anticipator. Make a note
here _____ of the anticipator setting.
M11901
IMPORTANT
Setting the heat anticipator allows the thermo-
stat to maintain accurate temperature control.
MOUNTING CLIPS
(FOR COVER)
TOP MOUNTING
HOLE
ADJUSTABLE HEAT
ANTICIPATOR
SETTING LEVER
(CT50A, CT51A ONLY)
FAN SWITCH
(CT51A ONLY)
SYSTEM SWITCH
(CT51A ONLY)
MOUNTING CLIPS
(FOR COVER)
BOTTOM
MOUNTING HOLE
TEMPERATURE
SETTING LEVER
69-0265ES
Publicidad
Tabla de contenido
Manuales relacionados para Honeywell CT50A
Resumen de contenidos para Honeywell CT50A
- Página 1 Contact your local waste management authority for instructions regarding recycling and proper disposal. For CT50A, CT51A Installation ! Before removing the old thermostat from the wall, look at it carefully to locate the heat anticipator adjustment mechanism.
-
Página 2: Wire And Mount New Thermostat
CT50A, CT51A, CT53A THERMOSTATS WIRE AND MOUNT ! Using a pencil point, move the heat anticipator pointer to the number it was set to on the old thermostat. If you NEW THERMOSTAT could not find the anticipator setting on the old thermostat, use the setting for your type of system shown in the table below. - Página 3 CT50A, CT51A, CT53A THERMOSTATS THERMOSTAT OPERATION ! On the CT51A, the system switch controls as follows: ! To observe: Place the system switch at HEAT position HEAT—heating system only operates. and fan switch at AUTO. ° ° OFF—heating and cooling systems are disconnected.
- Página 4 CT50A, CT51A, CT53A THERMOSTATS LIMITED 1-YEAR WARRANTY Honeywell warrants this product to be free from defects OR DAMAGE OF ANY KIND, INCLUDING ANY in the workmanship or materials, under normal use and INCIDENTAL OR CONSEQUENTIAL DAMAGES service, for a period of one (1) year from the date of RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY purchase by the consumer.
-
Página 5: Preparacion Para La Instalacion
Instalación de los modelos CT50A, CT51A ! Antes de extraer el termostato viejo de la pared, obsérvelo con cuidado para ubicar el mecanismo de ajuste del anticipador térmico. -
Página 6: Cables Y Montaje Del Nuevo Termostato
TERMOSTATOS CT50A, CT51A, CT53A CABLES Y MONTAJE DEL ! Con la punta de un lápiz, mueva el puntero del anticipador hacia el número en el que estaba el termostato viejo. NUEVO TERMOSTATO Si no puede encontrar el ajuste del anticipador en el termostato viejo, use el ajuste para su tipo de sistema que se muestra en la tabla que aparece a continuación. -
Página 7: Funcionamiento Del Termostato
TERMOSTATOS CT50A, CT51A, CT53A FUNCIONAMIENTO DEL TERMOSTATO ! En el modelo CT51A, los interruptores del sistema ! Siga los siguientes pasos: Coloque el interruptor del controlan lo siguiente: sistema en la posición CALEFACCION y el interruptor HEAT—opera el sistema de calefacción. -
Página 8: Garantia Limitada A 1 Ano
Esta garantía le brinda derechos legales específicos, Esta garantía no cubre los costos de extracción y usted podrá tener otros derechos que varían según o reinstalación. Esta garantía no se aplicará si Honeywell el estado. demuestra que el defecto o mal funcionamiento estaba causado por daños ocurridos mientras el producto estaba...