TOYAMA TDWT80E Manual Del Usuario página 28

ADJUSTING THE ACCELERATION CONTROL SYSTEM
The throttle control system must be properly adjusted so that throttle A can be operated to
accelerate the engine at maximum speed or to stop it. Adjustment is achieved by loosening the
locking nut of rod D, turning the accelerator counterclockwise to the maximum and moving the
throttle regulator C to the lowest position of the throttle guide rail C, then tighten the nut D.
Fig. 6 - Adjustment of control and acceleration system
ADJUSTING THE WHEEL OPENING
Three wheel opening steps are available by changing the mounting position of the wheel
hubs or by swapping the right wheel from the left (Figure 7). Generally, a 640mm wheel aperture
is advisable and 800mm for plow and transport (trailer coupled).
If another implement is attached, the wheel opening shall be adjusted to meet.
Setting mode: Loosen the hub clamping bolts E. Place the wheel hubs in the desired
position. Then tighten the tightening nut of the hub E into the shaft and tighten the nuts or
alternatively remove the four nuts C on each side and shift the right wheel from the left, i.e. to
change the mounting direction of the ring B Note that the direction of the tire (spine) design must
match the direction of rotation of the wheels.
After adjustment of the wheel opening, tightening the clamping screws of the hub E should
be done before tightening the adjusting screw, otherwise the hub will not be securely engaged,
and will lead to failures.
Figura 7 - Adjusting the wheel aperture
A – Throttle
B – Throttle strap
C – Throttle regulator
D – Lifter lock and regulator
A – Tire
B – Rim / wheel
C – Wheel nut
D – Hub
E – Hub tightening screw
28