Operating The Washer - LG WM3360HVCA Manual Del Propietário

H ow to use washer
:
WARNING
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT
!
SAFETY INSTRUCTIONS before operating this appliance.
16

OPERATING THE WASHER

1. SORT LAUNDRY AND LOAD THE WASHER
Different fabrics have different care requirements. See the Cycle
Guide on page 13 for details. For best washing, sort clothes into
loads that can be washed with the same wash cycle.
2. PUT IN DETERGENT
Open the dispenser drawer and add detergent to the main wash
compartment in the dispenser drawer. Add bleach and fabric
softener as desired.
3. TURN ON THE WASHER
Press the ON/OFF button to turn on the washer. The lights around
the cycle selector knob will illuminate.
4. SELECT A CYCLE
Turn the cycle selector knob to the desired cycle. The display will
show the preset wash/rinse temperature, spin speed, soil level, and
option settings for that cycle.
5. SELECT CYCLE SETTING
If you would like to change the settings for that cycle, press the
option button(s) to display additional settings for that option.
Press the button again to cycle through the settings until the
desired setting is shown.
NOTE: To protect your garments, not every wash/rinse
temperature, spin speed, soil level, or option is available with every
cycle.
6. SELECT CYCLE OPTIONS
Select any additional cycle options, such as STEAM or
COLDWASH™ by pressing the button for that option, or by
pressing the OPTION button for additional options.
NOTE: To protect your garments, not every wash/rinse
temperature, spin speed, soil level, or option is available with every
cycle.
7. BEGIN CYCLE
Press the START/PAUSE button to begin the cycle. To pause the
cycle at any time, press START/PAUSE.
NOTE: If the temperature in the washer is too high, the door cannot
be unlocked until the washer has cooled. If the water level is too
high, select the Drain & Spin cycle (see the page 18 for details) to
drain excess water. Do not try to force the door open.
8. CHECK CYCLE TIME
The door will latch, the display will change, and the washer will
calculate the estimated time remaining. Once the washer has
calculated the estimated total cycle time, the washer will start.
NOTE: Washing time can be reduced significantly for small or
lightly soiled loads by selecting the Speed Wash cycle and setting
the Soil Level button to Light.
NOTE: The cycle time displayed may appear much longer than that
of a top loading washer. The displayed time is for the complete
cycle, rather than just the agitation portion of the cycle, as is
typically shown on a top-loading washer.