3. ATTACHING MOTOR KIT AND LARGE WIND BRACE:
A. Attach motor kit to upright frame. Use caution, as motor is heavy.
Hold motor in place until both braces are attached. Use hardware as
shown in Figure B.
B. Attach rear large wind brace at each end using hardware as shown
in Figure C.
C. Ensure the rod at the bottom edge of the door is fully extended. Put
the tabs in the track as shown in Figure D.
D. Make certain edge of door fabric is aligned and threaded into track
of door frame.
FiGure B
802447
03025
802449
Page 5
edGe oF
FaBric
taB on
rod end
FiGure c
FiGure d
tracK
802457
802465
01011
05-90101_0C