All Vehicles - Metra AT-586FT Manual De Instalación

3
Slide the DIN cage into the Radio Housing and
secure by bending the metal locking tabs down.
Slide the aftermarket head unit into the cage until
secure. Mount the Rear Support to the back of
the head unit using the hardware included with
the unit.
5
Fig. A
EXPEDITION, F-Series, F-150 Heritage EXCURSION, NAVAGATOR, BLACKWOOD
Re-connect the battery terminal and test the unit for proper operation. Remove the top
(2) Phillips screws securing the climate
assembly into the dash cavity and
climate control cluster with the
EXPLORER, E-Series Van, RANGER, WINDSTAR, B-Series Pickup, MOUNTAINEER
Re-connect the battery terminal and test the unit for proper operation. Snap the head unit/kit
assembly into the sub-

ALL VEHICLES

control cluster to the sub-dash. Slide the head unit/kit
mount the bottom legs of the kit to the same holes in the
(2) Phillips screws previously removed. (see Fig. A)
dash. (see Fig. B)
4
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Fig. B
2