Environmental Protection - Ratio AR125M Traducción De Las Instrucciones Originales

Hold your angle grinder with one hand on the
main handle and other hand firmly around the
auxiliary handle.
Always position the guard so that as much of the
exposed disc as possible is pointing away from
you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control material removal and
minimum overloading, maintain an angle
between the disc and work surface of
approximately 150 -300 when grinding.
Use caution when working into corners as
contact with the intersecting surface may cause
the grinder to jump or twist.
When grinding is complete allow the workpiece
to cool. Do not touch the hot surface.
7. OVErLOAd
Overloading will cause damage to the motor of
your angle grinder. This can happen if your angle
grinder is subjected to heavy use for prolonged
periods of time.
Do not in any circumstances; attempt to exert too
much pressure on your angle grinder to speed
up your work.
If your angle grinder becomes too hot, run you
angle grinder under no load for 2-3 minutes until
it has cooled to normal operation temperature.
woRKinG Hints FoR
YoUR GRindeR
1. Your angle grinder is useful for both cutting
through metals, i.e. for removing screw heads,
and also for cleaning / preparing surfaces, i.e.
before and after welding operations.
2. Different types of wheel/cutter will allow the
grinder to meet various needs. Typically, wheels/
cuttings are available for mild steel, stainless
steel, stone and brick. Diamond impregnated
discs are available for very hard materials.
3. If the grinder is used on soft metals such as
aluminum, the wheel will soon clog and will have
to be changed.
4. At all times, let the grinder do the work, do not
force it or apply excessive pressure to the wheel/
disc.
5 If cutting a slot ensures that the cutter is kept
aligned with the slot, twisting the cutter may
cause the disc to shatter. If cutting through thin
sheet only allow material, excessive penetration
can increase the chance of causing damage.
6. If cutting stone or brick, it is advisable to use a
dust extractor.
maintenance
remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
tRoUBlesHootinG
Although your new angle grinder is really very
simple to operate, if you do experience problems,
please check the following:
1. If your grinder will not operate check the power
at the main plug.
2. If your grinder wheel wobbles or vibrates,
check that outer flange is tight, check that the
wheel is correctly located on the flange plate.
3. If there is any evidence that the wheel is
damaged do not use as the damaged wheel may
disintegrate, remove it and replace with a new
wheel. Dispose of old wheels sensibly.
4. If working on aluminum or a similar soft alloy,
the wheel will soon become clogged and will not
grind effectively.
5. If a fault can not be rectified return the tool
to an authorized dealer or its service agent for
repair.
enViRonmental
pRotection
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. check with
your local authorities or retailer for recycling
advice.
35