American Standard EDGEMERE T018.50 Serie Instrucciones De Instalación página 2

1
INSTALL VALVE TRIM
• Figure 1. Remove plaster guard from valve. Push
CAP (1) over VALVE CARTRIDGE (2) until seated
against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and
attach to valve body with LONG SCREWS (4). Mount
DECORATIVE PLATE (5) to ESCUTCHEON (3) by
aligning three PINS (6) on back side of DECORATIVE
PLATE (5).
2
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
• Remove pipe cap and plug from shower and tub
rough piping.
• Slip DECORATIVE PLATE (5), then slip TUB SPOUT (1)
onto tub nipple and tighten with 2.5 mm Hex Wrench.
CAUTION: Protect finish on TUB SPOUT when
installing.
• Install SHOWER ESCUTCHEON (2) onto SHOWER
ARM (3). Apply sealant or Teflon tape to threads on
both ends of SHOWER ARM (3) and thread longer
leg of SHOWER ARM (3) into shower elbow.
• Thread SHOWER HEAD (4) onto SHOWER ARM (3).
CAUTION: Protect finish on SHOWER HEAD and
ARM when installing.
PLASTER
GUARD
Figure 1.
Figure 2.
Protect finish on SHOWER HEAD
CAUTION
and TUB SPOUT when installing.
SHR.
ELBOW
PIPE
PLUG
TUB FILLER
NIPPLE
1 -
1 /
2 "
R E
F .
- 2 -
2
3
4
5
2
3
PIPE
CAP
5
2.5 MM HEX
WRENCH
M965807 Rev. 1.1 (10/19)
1
6
4
1