Determine Type Of Use And Mounting Side Of The Sensor Pillars; System Configuration / Pillar Connection (Master-Slave) - Fiessler RAZL-2CO Manual Del Usuario

People Counter RAZL-2CO (Translation)
Connect slave pillar with
Step 2:
master pillar

4.4 Determine type of use and mounting side of the sensor pillars

"Installation of the counting light barrier..." and "Type of use" must be set. Incoming and outgoing persons can only be detected correctly if the
setting corresponds to the actual installation location of the pillars and their use as an entrance and/or exit.
Step Device configuration of the
1: master pillar
Wait until the slave pillar
Step
appears in the device over-
2:
view
Step Device configuration of the
3: slave pillar
possibly configure further pil-
...
lars

4.5 System configuration / pillar connection (master-slave)

Step 1:
Call up the menu (via menu symbol in the top left-hand corner), select system configuration
Step 2: Enter the maximum number of persons allowed and make further settings
Maximum permitted number of persons must be set.
Step 3:
Step 4:
Disable configuration mode again (log off via lock symbol)
Fiessler Elektronik GmbH & Co. KG
Buchenteich 14, D-73773 Aichwald
In the menu
Select device overview
Allow pairing
Select setting wheel of the
master pillar
Configuring the master pillar
If "Active" appears in the status bar, the slave pillar can be configured.
Select the setting wheel of the
slave pillar
Configure slave pillar
... (like steps 2 and 3)
Save settings (via the Save field at the bottom)
-27-
Phone: +49 (0)711 - 91 96 97 - 0
Fax: +49 (0) 711 - 91 96 97 - 50
Internet: http://fiessler.de
E-Mail: info@fiessler.de