Nostalgia Products HDC-701 Manual De Instrucciones página 6

ENGLISH
ASSEMBLY INSTRUCTIONS
1. Lay the cart body on its side. Take one of the base feet (legs) and attach it to the cart
body so that the longer leg is attached at the same end (of the cart) as the power and
heat controls. To attach each leg it will take four of the 1" screws. (See Illustration F)
2. Set one linking bar at each end. Fit the linking bar down over the extrusion on the
base foot securely, and use one 1" screw at each end to attach.
3. While the cart is still on its side, attach the second base foot. Make sure the base foot
slides under the top lip of the cart and into position. Then ease both extrusions (on
the base foot) into the linking bar at both ends matching up the screw holes. To
secure these it will take four 1" screws.
Helpful tip: At this point, turn the entire cart body on end. This will allow you to view
and tighten any loose screws and catch any screw (holes) you might have missed.
4. Lay the cart on its side once again to attach the wheels. Put one wheel rod into the
hole from the inside out. Place one spring washer between frame and wheel and
screw on ball cap nut using wrench to tighten. (See Illustration G)
5. Now turn the cart over so that you can attach the second wheel.
6. Set the double upper shelf with sneeze/wind guard on the top of the cart. Line up the
holes on each end and use four 1/4" pointed end screws to secure.
7. While you have the cart on its side, attach the cold box to the cart at the roller end of
the cart. This will allow the floor to support the weight of the cold box while you locate
the screw holes and attach the box using four 1/4" flat end screws.
8. Stand the cart up. Attach the pulling bar assembly (side shelf) above the power and
heat control selection controls using the four 1" screws.
Tip: If you secure one upper left corner screw then fasten one lower right corner
screw, the tray is now attached sufficiently to use both hands to fasten the remaining
two screws and level the tray.
4
F
G