Maytag M1200 Manual Del Usario página 9

3.4.2 T
URNING ON YOUR IRON
1. Rest unplugged iron on its heel.
2. Plug the iron into a grounded electrical outlet.
You will hear a beep when plugged in, but the iron is NOT heating up yet.
3. To heat up, press the Temperature Control Button 1 time to
This is the lowest setting.
4. A single light will flash for about 30 seconds.
5. Light stops flashing and beeps.
6. Iron away.
For Silk/Wool setting ••; at step 3, press Temperature Control Setting Twice.
For Cotton setting •••; at step 3, press Temperature Control Setting Three times.
For Linen setting MAX; at step 3, press Temperature Control Setting 4 times.
3.5 Turning Off Your Iron
1. Press down on the Temperature Control Setting for
about 3 seconds. See Figure H.
2. Lights will turn off while a beep sounds at the same time.
3. The iron has been turned off.
4. Unplug the iron.
5. Stand iron upright on its heel to cool down.
Note: The iron will remain hot after turning off. Allow ample time to cool down
prior to handling and storing.
• for (Nylon/Synthetics).
Figure H
7