Silverline 870944 Traducción Del Manual Original página 7

870944
3. To switch 'off' the sander, push the On/Off switch in to the 'O' position
WARNING: Always wait until the machine has stopped vibrating completely before
putting it down. Always disconnect from the power supply after use.
Sanding
• If the tool is connected to a vacuum dust extraction system, switch the
extraction device 'on' before switching on the sander. Switch the sander 'off'
first, then the vacuum system
• Move the machine in a circular motion over the workpiece surface, applying
an even, moderate pressure until you reach the desired surface finish
WARNING: Excessive pressure does not lead to a faster removal of material; it
will, however, lead to premature wear of the sanding disc, and may cause damage
to the machine.
• If there are still scratches on your workpiece after sanding, refer to 'Selecting
the right grade of sanding disc'
Accessories
• A range of accessories and consumables, including Hook & Loop Discs
Punched 10pk 60 Grit (647920), 120 Grit (382903), and 240 Grit (206505),
is available from your SILVERLINE stockist. Spare parts can be obtained from
toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any
inspection, maintenance or cleaning.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised SILVERLINE service centre. This
advice also applies to extension cords used with this tool
Emptying the dust extraction bag
WARNING: Always switch off and disconnect from the power supply before
detaching the dust extraction system.
WARNING: Always wear respiratory protection, eye protection and gloves when
emptying the Dust Bag (5).
Note: For optimum dust removal, empty the Dust Bag when it is no more than
half full.
1. Detach the Dust Bag from the Dust Extraction Port of the sander by pulling and
twisting the bayonet fitting on the Dust Bag Collar (6)
2. Dispose of the waste
3. Attach the Dust Bag to the Dust Extraction Port of the sander by pushing and
twisting the bayonet fitting on the Dust Bag Collar
Note: If the sanding dust contains harmful substances, such as particles from
old paint, varnish, surface coatings etc., always dispose of according to laws and
regulations.
Note: Always clean the tool THOROUGHLY when switching from sanding wood to
sanding metal and vice versa.
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves
when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient,
a mild detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation
holes (where applicable)
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray
lubricant
240W Random Orbit Sander
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or
visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised SILVERLINE service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no
longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way
to dispose of power tools
www.silverlinetools.com
7