Assembly And Initial Commissioning; Transport; Storage - Pfannenberg PWS 6302 Serie Manual De Instrucciones

GB
3

Assembly and initial commissioning

3.1

Transport

WARNING
Danger due to uncontrolled movements
Improper securing of the unit can result in severe accidents.
 Loading must only be carried out by trained, qualified personnel.
 Lash the unit correctly for transport on a truck or trailer.
 Only use lashing straps with an adequate rated strength.
 Use slip-resistant materials for securing, e.g. anti-slip mats.
 When loading by crane, do not walk or stand under the raised units.
NOTE
Danger of material damage during transport and setting down of the units.
 Improper unit securing or uncontrolled movements can cause damage.
 Exercise maximum caution during movement and transport of the units.
 Always transport the unit in the position of use.
 Transport of the air/water heat exchangers must always take place with the packaging provided at the factory. It
comprises an outer carton, bottom plate and base and top cushions.
Transporting air/ water heat exchanger
Requirements
- Air/water heat exchangers are in the packaging provided by the factory.
Required tools and material
- Lashing straps, loading crane, if applicable
Procedure
 Secure properly for transport with lashing straps. Always transport in the position of use.
 Only hoist air/water heat exchangers on the housing.
 Always raise air/water heat exchangers slowly and evenly and set down safely.

Air/water heat exchanger was properly transported and loaded.
3.2

Storage

•
Do not expose air/water heat exchangers to temperatures higher than +70 °C in storage.
•
Always store air/water heat exchangers in the position of use.
 The warranty will no longer apply if these instructions are not observed.
Operating manual PWS and PWI 6302 086100049a © Pfannenberg GmbH Page 9 / 31