Assembly Of Pwi Air/ Water Heat Exchange (Installation) - Pfannenberg PWS 6302 Serie Manual De Instrucciones

GB
3.4.3

Assembly of PWI air/ water heat exchange (Installation)

Attaching cut-out for PWI air/water heat exchangers
Requirements
- All general requirements are fulfilled, see
- The unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
 Use a protective cover to protect the switch cabinet from chips.
 Provide the switch cabinet with cut-out (1). For prescribed dimensions (in mm), see figure Switch cabinet
exterior view cut-out PWI (2).
 Deburr the cut edges.
 Remove chips and assembly waste from the switch cabinet.
 Cut-out (1) has been created.
Operating manual PWS and PWI 6302 086100049a © Pfannenberg GmbH
2
Figure 8 - Switch cabinet exterior view
Cut-out PWI air/water heat exchangers
General assembly requirements
1
2
Page 14 / 31