Publicidad
Step 10
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the UPRIGHTS (CCC and DDD). Set the ADJUSTABLE SHELF (J2) onto the METAL PINS.
Center a SCREW COVER (20P) over the head of each SCREW and gently tap in with your hammer.
å
Apply the WARNING LABEL (1L) to the TOP (EE3). You should be able to read the label when the TV is removed from the
å
unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
NOTE: Please read the back page of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story at Walmart.com or
20P
B2
1R
(4 used)
2R
Page 14
EE3
J2
DDD
25 lbs.
40 lbs.
total
1L
50 lbs.
CCC
A2
411660
WARNING
Never use this furniture with a TV
that is too large or too heavy. Severe
injury or death can occur. The TV and
furniture will be unstable and may tip.
-The TV must weigh less than 50 lbs.
-The base of the TV must be able to
sit completely on this shelf.
Refer to instruction book for
complete safety information.
Note: This is a permanent label. Do
not try to remove. Surface will be
damaged.
08/05
2 6 9 2 2 0
20P
(4 used)
To cover screws
www.sauder.com/service
269220
Publicidad
