Mains Connection - Work WCR 35 Manual De Usuario

shield has to be connected on both ends.

MAINS CONNECTION

The mains connection of the
receptacle. It meets all of the international safety certification requirements.
Please make sure that all units have a proper ground connection. For your own safety, it is
advisable not to remove the ground connection within the units or at the supply, or fail to make
this connection at all. The audio ground of the
isolate it from the supply earth. It is therefore not advantageous to attempt ground loop problem
solving using thismethod.
Operating Voltage Selector
Before you switch on the unit, check that it is configured to match your AC mains voltage
requirements. If it does not comply, then it is necessary to switch the operating voltage to the
correct supply requirements before turning on the unit, otherwise the unit could be severely
damaged. You will find the voltage selector at the back, adjacent to the IEC receptacle.
Please note that the AC voltage selection is defined by the position of the selector holder. If you
intend to change the operating voltage, move the voltage selector switch to up or down.
Matching the twomarkers monitors the selected voltage.
Safety Fuse Replacement
A safety fuse protects the unit from serious defects. If the fuse blows, this is a warning sign and
always indicates that the circuit is overloaded. The fault must always be repaired before the
fuse is replaced.
If the safety fuse blows and needs replacing after the unit is repaired, please make sure that
you replace it only with the identical type and rating. NEVER use fuses of different ratings or
cover faulty fuses with aluminum foil. This can cause fire and electric shocks and will endanger
your life and the lives of others.
For 200-240 Volts the fuse rating is 125 mA slow-blow and 250 mA slow-blow for mains
voltages of 100-120 Volts.
WCR 35 Front & Rear Panel Controls & Connections
Front Panel
[1] [2] [3] [5]
[1] INPUTGAINcontrol
Two INPUT GAIN potentiometers (+/-12 dB ) match the sensitivity of the
any console. Each has an associated CLIP LED.
[2] X'OVER FREQ. control
The crossover frequencies are set by adjusting the X'OVER FREQ. Potentiometer at each
channel.
Reference Manual
WCR 35 is made by using a mains cable and a standard IEC
WCR 35 is internally capacitor de-coupled, to
[6] [7]
WCR 35 's inputs to
Page 5