Rear Panel - Work WCR 35 Manual De Usuario

[3] RANGE switch
Crossover frequencies from 80 to 900 Hz or 800 Hz to 9 kHz respectively are chosen by the
RANGE switch.
[4] LF /MF/ HF GAIN control
Each band has it's own LF/HF GAIN ( +6 dB ) control to allow some fine-tuning of the system to
give (usually) a flatter frequency response.
[5] LF/MF/HFMUTE switch
The MUTE button enables easy auditioning of the selected band(s).
[6] MODE switch
Stereo 3-way ormono5-wayoperation is chosen by the MODE switch.
[7] MONO BASS switch
In stereo mode the bass outputs may be summed in mono via the MONO BASS switch.

Rear Panel

[1]
REAR PANEL
[1] MAINS CONNECTOR / FUSEHOLDER / VOLTAGE SELECTOR
Before you connect the unit, pleasemakesurethatthedisplayedvoltagecorresponds to your
mains supply.
Please note that the AC voltage selection is defined by the position of the selector holder. If you
intend to change the operating voltage,move
the voltage selector switch to up or down. Matching the two markers monitors the selected
voltage.
Please note that, depending on themains voltage supplied to the unit, the correct fuse type and
ratemustbeinstalled.
Please use the enclosedmains cable to connect the unit to themainspower supply.
[2] HIGH / MID/LOWOUTPUTS
Your WCR 35 provides 6 outputs for stereo and 5 for mono operation.
[3] INPUTS
Inputs are electronically balanced (2 for stereo, 1 formonooperation).
Once again two legending stripes refer to stereo 3-way (top) and mono 5-way operation
(bottom) respectively. In mono 5-way operation
certain inputs and outputs do not apply, and are not legended.
Page 6
[2] [3]
Reference Manual