Preparation For Wiring; Wiring; Fan Assembly - Craftmade Brilliante BRC52 Guia De Instalacion

5. Preparation for Wiring.

Remove 4 motor mounting screws and lock
washers from the bar on the top of motor
assembly; leave rubber cushions in place. Lift
motor assembly to hanging bracket and place
one end of motor assembly in hanging bracket
slot. This will allow motor assembly to hang out
of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.

6. Wiring.

NOTE: See instructions above (Section 5) in order to
temporarily hang fan on hanging bracket during wiring.
CAUTION: Be sure outlet box is properly grounded and that a
ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes or
Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to in the instructions
below, please use a qualified electrician.
When fan is secured in place on the hanging bracket,
electrical wiring can be made as follows:
Connect BLACK and BLUE wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from ceiling
with wire connector provided.
Connect all GROUND (GREEN) wires from fan together to
BARE/GREEN wire from ceiling with wire connector provided.
If you intend to control the fan light with a separate light
switch, connect BLUE wire from fan to the BLACK supply from
the independent switch.
* Wrap each wire connector separately with electrical tape as
an extra safety measure.

7. Fan Assembly.

Remove motor assembly from temporary hanging
slot in hanging bracket. Carefully push wiring and
wire connectors into outlet box. Slide one end of bar
on motor assembly through one of the openings in
the hanging bracket. Lift the other end of the motor
assembly and slide it through opposite opening on
hanging bracket. Align holes in top of motor
assembly with holes in hanging bracket. Secure
motor assembly to hanging bracket with lock
washers and motor mounting screws that were
previously removed (Section 5).
hanging
bracket
motor
mounting
screws and
lock washer
BLACK
BLACK
BLUE
hanging
bracket
hanging
bracket
opening
motor
mounting
screws and
lock washers
page 5
hanging
bracket slot
motor assembly
GROUND (GREEN OR BARE)
GREEN
GREEN
WHITE
WHITE
*
motor assembly
hanging
bracket
opening
motor
mounting
screws and
lock washers
motor assembly
slot