Culligan FM-5 Manual Para El Uso Y El Mantenimiento

Faucet Mount Filter
Use and Care Manual
Model FM-5
Congratulations!
You have purchased a quality Culligan
better tasting water. For over 60 years, Culligan has been supplying better quality
water to the world. Trust Culligan for the best water you can get, anytime you want
it. Our goal is to provide you with the highest quality water and the best possible
service. For your home. For your health. For your family.
Operating Specifications
Pressure Range: 30-125 psi (2.1–8.6 bar)
Temperature Range: 40–100°F (4.4–37.8°C)
Rated Service Flow: 0.5 gpm at 60 psi (1.9 Lpm @ 4.08 bar)
Filter Capacity: FM-5: 120 gallons (452 L)
Parts Included
1. Filter body with "3-way spray" valve handle
2. Filter cartridge
3. Faucet adapters (3 metal with washers)
4. Filter monitor
5. Attachment Collar
6. Gasket and screen (installed in filter body)
4
2
The FM-5 is Tested and Certified by NSF International to NSF/ANSI Standard 42 for the
aesthetic reduction of Taste and Odor, Chlorine, Particulate Class I and Bacteriostatic
Effects. Standard 53 for the reduction of Cyst, Turbidity, Asbestos and Lead.
11/03 145880 Rev B
Technical Support: 1-800-645-5426
® water filter designed to give you cleaner,
157680
155696
144736
157810
5
3
6
1
Precautions
WARNING: Do not use with water that is microbiologically unsafe or of
unknow quality without adequate disinfection before or after the system. Systems
certified for cyst reduction may be used on disinfected waters that may contain
filterable cysts.
CAUTION: This filter must be protected from freezing, which can cause cracking
of the filter and water leakage.
NOTE:
• For cold water use only (when in the filtered water position).
• Make certain that installation of this system complies with all state and local
laws and regulations.
• The contaminants or other substances removed or reduced by this water
treatment device are not necessarily in your water.
• The filter cartridge has a limited service life. Changes in taste, odor, and/or
flow of the water being filtered indicate that the cartridge should be replaced.
• After prolonged periods of non-use (such as during a vacation), it is
recommended that the system be flushed thoroughly. Let water run for 5
minutes before using.
Selecting the Correct Faucet
Adapter
(1) From the adapter kit, select the large adapter with the internal threads (Fig.1).
(2) Select one of the larger rubber washers and place it securely inside of the larg-
er adapter (Fig. 2).
(3) Remove the aerator from your faucet and determine the type of faucet threads:
A. External threads: Use the larger adapter and washer by themselves.
B. Internal threads: Through trial and error, select the smaller adapter (with
external threads) that fits your faucet. Make sure there is a washer located
inside the larger adapter, then screw the smaller adapter into the large
adapter and tighten it securely. (Fig. 3).
NOTE: Adapters are included which will fit most faucets. To create a tight seal, you
may need to use the gasket from your faucet's aerator in addition to the washers
included with the adapters. If the adapters do not fit, it is recommended that you
consult your local plumbing or hardware supplier for assistance in obtaining the
correct thread adapter.
2
1
(M-F 7:30 am - 5:00 pm CST)
3
1