Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Performance Data
Important Notice: Read this performance data and compare the capabilities of
this system with your actual water treatment needs. It is recommended that,
before installing a water treatment system, you have your water supply tested to
determine your actual water treatment needs.
This system has been tested according to NSF/ANSI 42 and 53 for reduction of the
substances listed below. The concentration of the indicated substances in water
entering the system was reduced to a concentration less than or equal to the per-
missible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.
FM-5 with FM-5R Cartridge
Influent Challenge Max. Permissible Product Reduction
Substance
Concentration
Water Concentration Requirements
Standard 42 Aesthetic Effects
Chlorine
2.0 mg/L ± 10%
Particulates at least 10,000 particles/mL
(0.5 to < 1µm)
Class I
Bacteriostatic
System passes NSF Std. 42 for Bacteriostatic Effects
Taste and Odor
System passes NSF Std. 42 for Taste and Odor Reduction
Standard 53 Health Effects
Cysts
2)
Minimum 50,000/L
Turbidity
11 mg/L ± 1 NTU
0.5 NTU
Lead 6.5 pH
0.15 mg/L ± 10%
Lead 8.5 pH
0.15 mg/L ± 10%
Asbestos
10
7
to 10
8
fibers/L > 10
micrometers in length
Flow Rate = 0.5 gpm (1.9 Lpm) Capacity = 120 gallons (454 L) or 3 months
2)
Based on the use of microspheres or Cryptosporidium parvum oocysts
Testing was performed under standard laboratory conditions, actual performance may vary.
WARNING:
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system. Systems
certified for cyst reduction may be used on disinfected waters that may contain
filterable cysts.
NOTE: Substances reduced are not necessarily in your water. Filter must be
maintained according to manufacturer's instructions, including replacement of filter
cartridges.
NOTE: The term 'bacteriostatic' indicates that the system limits the passage or
growth of bacteria that may already exist in the incoming water. It does not mean
that water leaving the system is safer to drink than water entering the system.
Test Conditions:
Flow Rate:
0.5 gpm (2.3 Lpm)
Inlet Pressure:
60 psi (4.1 bar)
Ph :
7.5 +/- 0.5
Temperature:
68°F +/- 5°F (20°C +/- 2.5°C)
Operating Requirements
Pressure:
30–125 psi (2.1 – 8.6 bar)
Temperature:
40 –100°F (4.4–37.8°C)
Turbidity:
5 NTU Max
Suggested Retail Price for Replacement Filter Cartridges:
FM-5R:
$19.99
NOTE: Price subject to change. Contact your local retailer or call:
1-888-777-7962 for current replacement cartridge pricing.
Technical Support: 1-800-645-5426
Minimum
Average
Reduction
Reduction
≥ 50%
89.4%
≥ 85%
99.9%
99.95%
99.99%
99.99%
97.7%
99%
0.010 mg/L
98%
99%
0.010 mg/L
98.4 %
99%
99%
99.95%
99.95%
State of California
Department of Health Services
Water Treatment Device
Certificate Number
Date Issued: April 19, 2000
Trademark/Model Designation
Culligan FM-5
Manufacturer: Culligan
The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section
116830 of the Health and Safety Code for the following health related contaminants:
Microbiological Contaminants and Turbidity
Cysts (protozoan)
Turbidity
Organic Contaminants
None
Rated Service Capacity:
120 gallons
Do not use where water is microbiologically unsafe or with water of unknown quality, except that systems
claiming cyst reduction may be used on water containing cysts.
IOWA RESIDENTS ONLY:
Store or seller's name
Address
City
State
Zip
Telephone
Seller's signature
Customer's signature
Date
(M-F 7:30 am - 5:00 pm CST)
00 -
1430
Replacement Elements
FM-5R
Inorganic/Radiological Contaminants
Asbestos
Lead
Rated Service Flow:
0.5 gpm
3
Publicidad
Tabla de contenido
