Dash Disassembly - Metra 95-6531HG Instrucciones De Instalación

1. Using Metra's 86-3528 radio
removal tools, pull the factory radio
from the dash. (Figure A)
2. Remove (2) T-25 Torx screws from
the top of the factory radio trim
panel opening, and (2) T-25 Torx
screws from the bottom of the
opening. (Figure B)
3. Pull down slightly on the top center
of the panel, and then unclip and
remove the panel. (Figure C)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
95-6531HG
4. Remove (4) T-10 Torx screws
securing the factory radio clip
brackets to the panel. (Figure D)
5. In the sub-dash cavity of the
vehicle, grind or cut the (2) silver
rivets from the left and right side.
(Figure E)
6. Cut and remove the shaded portion
of the sub-dash cavity as shown.
(Figure F)
Note: Take caution not to cut
the vent ducts.
Continue to kit assembly.
2
(Figure D)
(Figure E)
Remove
shaded
area
(Figure F)