NORTH STATES 4977 Manual De Instrucciones página 4

2. Remove and discard the protection bushings marked with "REMOVE".
Insert upper bushings and lower bushings into the gate frame or extension(s).
extension(s) into gate frame. Slide the 4 tension bolts with rubber pads completely into the
bushings (2A) (2B). When installing and detaching the extension(s), move the extension(s) in an
upright position. Do not tilt (2C).
W A R N IN G
W A R N IN G
!
Discard the protection bushings marked with "REMOVE" to prevent choking hazard.
2 A
Insert bushings into the gate
frame or extension
3. Place the gate in the opening so that the bottom of the gate frame is completely at on the
oor (3A). To secure the gate, fasten the mounting cups to the wall on the vertical lines from
the oor with the screws or double coated tapes provided, so that the mounting cups at the
top are vertically above those at the bottom (3B) (3C).
Note: Do not use this gate if it can't be installed to walls, door frames or posts tightly and atly.
If the gate is not installed vertically, the automatic close feature will be hindered.
(s)
.
e xte ns ion
2 C
2 B
gate frame
e xte ns ion
OK!
upper bushing
bolt
tension knob
Page 4
Place