Bradley Professional Serie Manual Del Usuario página 25

Ahumador digital con capacidad para 5 estantes
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

QUICK REPAIRS
Only an authorized technician may work on electrical repairs on this appliance.
Bradley Technologies Canada Inc. accepts no responsibility for any malfunction or damage which is
caused by unsuitable electrical repairs.
Bisquette burner and burner sensor removal
This error occurs when one or both of the elements are not supplying heat to the
bisquette burner. If burner temperature is less than 100 degrees and or has increased less than 3 degrees,
within 1 minute the alarm will be displayed and beeping alarm will sound.
To change the burner* follow these steps:
1. Turn off the power switch. See the Switch (9) location on page 7.
2. Disconnect the power cable from the electrical outlet.
3. Ensure adequate time to cool down the smoker after use.
4. Remove the bisquettes and bisquette tube (2).
5. To loosen the bisqette assembly, remove the phillips screw (5) located in the cabinet ( page 9).
6. To remove the cables cover ( page 23) (4) remove the phillips screw (3) located in the side cabinet.
7. Pull out the cables cover vertically.
8. Disconnect 2 cable harness connectors.
9. Gently pull out the bisquette dispenser assembly.
10. Remove the burner controller (15).
11. Remove 4 bottom screws connecting the bisquette dispenser, middle plate(9) and bottom plate
(14) together.
12. Disconnect both bisquette heater cables (10) and sensor cable (11).
13. Loosen 4 screws holding the bisquette burner plate and remove it.
14. Loosen the bisquette burner sensor, remove the screw holding it and gently pull out the sensor.
*NOTE This procedure also applies when changing drive motor (13). To change the positioning switch (8)
loosen the 4 screws on bisquette dispenser cover (6). Remove the cover to access the switch (8)
1.
Bisquette dispenser assembly
2.
Feeding tube
3.
Feeding tube support bracket
Slide rail*
4.
located inside of the smoker cabinet
*
5.
Fastening screw
6.
Bisquette dispenser cover
7.
Turn table
8.
Positioning switch
9.
Bisquette dispenser middle plate
10. Bisquette heaters
11. Bisquette burner sensor
12. Bisquette burner plate
13. Drive motor
14. Bisquette dispenser bottom plate
15. Burner controller
24 |
P a g e

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bs1019btBs1019btce

Tabla de contenido