Step 7: Backguard Installation - Thermador PRO-HARMONY P304 Instrucciones De Instalación

FIG. 8
Install screws
at 12 circled
locations
Back panel of backguard is positioned behind
the guide channels on the back of the range.
The backguard must be attached before sliding the range into the final installed position. A Low Back or High
Shelf backguard must be installed when there is less than a 12" clearance between combustibles and the
back of the range above the cooking surface. (See Fig. 2A and 2B on Page 6).
An Island Trim is available for covering the backguard mounting flanges for island installations, where there
is a minimum of 12" of horizontal clearance between combustibles and the back of the range. (See Fig.
2B on Page 6).
The backguard is inserted, as shown in Fig. 8, behind the guide channels on the back of the range. Using
the (12) sheet metal screws provided, fasten the backguard to the back of the range and to the flange of
the sheet metal surrounding the cooling fan.
To avoid possible burn or fire hazard, a backguard designed specifically for this range must be installed
whenever the range is used.
Chart C: Backguard Kit Model Numbers
Range Model No.
P304 Included with Range
P36

Step 7: Backguard Installation

WARNING
6" Std. Low Back
N/A
9" Low Back 22" High Shelf
N/A GP30HS
GP36LB GP36HS
15
Front of Unit
3" Island Trim
GP30IT
GP36IT