HI-Q TOOLS PM3500 Guía De Usuario página 9

CONTACTING POLO
URL: www.polo-motorrad.de
Email: info@polo-motorrad.com
Mailing Address: Polostr. 1
D-41363 Jüchen
ABOUT PM3500 Each process is uncomplicated and
easy to accomplish. The PM3500 is designed for charging
all types of 12V lead-acid and 12V lithium-ion batteries,
including Wet (Flooded), Gel, MF (Maintenance-Free), CA
(Calcium), EFB (Enhanced Flooded Battery), AGM (Ab-
sorption Glass Mat), and LIB (Lithium Ion) batteries. It
is suitable for charging battery capacities from 2 to 120
Amp-Hours and maintaining all battery sizes.
GETTING STARTED Before using the charger, carefully
read the battery manufacturer's specific precautions and
recommended rates of charge for the battery. Make sure
to determine the voltage and chemistry of the battery by
referring to your battery owner's manual prior to charging.
MOUNTING The PM3500 has four external holes for
mounting. Mount the charger in a desired location with #6
self-drill screws. Make sure there are no obstructions be-
hind the mounting surface. It is important to keep in mind
the distance to the battery. The DC cable length from the
charger, with either the battery clamp or eyelet terminal
connectors, is approximately 75-inches (1900mm).
CHARGING MODES The PM3500 has eight modes:
Standby, 12V NORM, 12V COLD/AGM, 12V NORM [Small],
12V COLD/AGM [Small], 6V NORM, 12V LITHIUM, and
12V REPAIR. Some charge modes must be pressed
and held for three seconds to enter the mode. These
"Press and Hold" modes are advanced charging modes
that require your full attention before selecting. "Press
and Hold" are indicated on the charger by a red line. It is
important to understand the differences and purpose of
each charge mode. Do not operate the charger until you
confirm the appropriate charge mode for your battery.
Below is a brief description:
Mode
In Standby mode, the charger is not
charging or providing any power to
the battery. Energy Save is activated
Standby
during this mode, drawing microscopic
power from the electrical outlet. When
selected, an orange LED will illuminate.
No Power
For charging 12-volt Wet Cell, Gel Cell,
12V
Enhanced Flooded, Maintenance-Free
NORM
and Calcium batteries. When selected,
a white LED will illuminate.
14.5V | 3.5A | 2-120Ah Batteries
For charging 12-volt batteries in cold
12V
temperatures below 50ºF (10ºC) or
COLD/
AGM batteries. When selected, a blue
AGM
LED will illuminate.
14.8V | 3.5A | 2-120Ah Batteries
For charging 12-volt Wet Cell, Gel Cell,
12V
Enhanced Flooded, Maintenance-Free
NORM
and Calcium batteries. When selected,
[Small]
a white LED will illuminate.
14.5V | 900mA | 2-35Ah Batteries
For charging 12-volt batteries in cold
12V
temperatures below 50ºF (10ºC) or
COLD/
AGM batteries. When selected, a blue
AGM
LED will illuminate.
[Small]
14.8V | 900mA | 2-35Ah Batteries
Explanation
17