AVS Bugflector Instrucciones De Instalación

Bugflector
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the hood shield is properly anchored to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
Contents
NOTE: Actual product may vary from illustration.
Tools Required
Car Wash Supplies
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash your vehicle's hood to remove any debris and/or dirt.
• Dry the hood with a clean towel.
• Do NOT install hood shield if vehicle does NOT have a factory installed hood seal / gasket.
Installation Steps
Open hood. Note the location of rubber seal on leading edge of hood.
Use car wash supplies to clean the hood surface area underneath the
Rubber seal
1
Installation Instructions
®
- Bugflector II
Hood Shield
Clean Towel
NOTE: Actual application may vary slightly from illustrations.
rubber seal.
® ®
- Carflector - Chrome Hood Shield
Bump On
x4
Phillips Screwdiver
Center hood shield in place on hood. Use a grease
pencil to mark the locations on rubber seal that cor-
2
Page 1 of 3
I - Sheet Number BF124 Rev.A
Screws x6
Washer x6
(98023)
(98022)
Drill with 1/8" bit
and 1/2"stop collar
respond to (6) holes on hood shield flange.
™
Grease pencil