Layout And Items Supplied - EINHELL TE-TS 2025 UF Manual De Instrucciones Original

alcohol or medication. A moment of inatten-
tion when using the electric tool can result in
serious injuries.
•
Do not use an electric tool with a defective
switch. An electric tool that cannot be swit-
ched on or off is dangerous and must be
repaired.
•
Keep unused electric tools out of the reach of
children. Do not allow people who are not fa-
miliar with the tool or who have not read these
instructions to use the tool. Electric tools are
dangerous if they are used by inexperienced
people.
•
Keep your cutting tools sharp and clean.
Carefully maintained cutting tools with sharp
cutting edges will jam less and are easier to
control.
•
If the connection lead on the electric tool is
damaged, it must be replaced by a specially
prepared connection lead available from our
customer service organization.
•
Have your tool repaired only by trained per-
sonnel using only genuine spare parts. This
will ensure that you tool maintains its safety
standard.
•
The machine has to be set up where it can
stand securely.
•
All covers and safety devices have to be pro-
perly fitted before the machine is switched on.
•
It must be possible for the blade to run freely.
•
When working with wood that has been pro-
cessed before, watch out for foreign bodies
such as nails or screws etc.
•
Before you actuate the On/Off switch, make
sure that the saw blade is correctly fitted and
that the machine's moving parts run smoothly.
•
Follow the instructions for lubrication and
changing tools.
•
Keep handles dry, clean and free from oil and
grease.
•
Keep the push stick or handle for a push
block at the machine at all times, even when
you are not using them.
•
Use only the transport device for transporting
the machine.
•
While you are moving the machine it is best
to cover the top part of the blade, for example
using a guard.
Do not lose these safety instructions.
Anl_SA_TE_TS_2025_UF_SPK8.indb 26 Anl_SA_TE_TS_2025_UF_SPK8.indb 26
GB

2. Layout and items supplied

2.1 Layout (Fig. 1-3, 7-8, 11-14)
1 Sawing table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Complete parallel stop
8 Hand wheel
9 Adjusting and locking grip
10 Base frame
11 On/Off switch
12 Eccentric lever
13 Adjustable rubber foot
14 Cross stop
15 Screw
16 Extractor adapter
17 Countersunk head screw
18 Hole (splitter)
19 Fastening screw
20 Screw
21 Groove
22 Scale
23 Stop rail
24 Holder
25 Slot
26 Screw
27 Slot
28 Guide rail
29 Mounting plate
30 Splitter counter bearing
31 Wheel
32 Holder for parallel stop
33 Table width extension
34 Tool hook
35 Lever
36 Nut
37 open-ended spanners
38 open-ended spanners
39 Table extension
40 Flange
41 Overload switch
42 Cable store
a Screw
b Spring washer
c Washer
d Washer
e Screw
f Axle screw
g Washer
h Spacer tube
- 26 -
05.12.2016 13:55:38 05.12.2016 13:55:38