Parts Names - StarMax STFFS40-8JAF Instrucciones De Operación

PARTS NAMES

ROUND BASE & COLUMN UNIT ASSEMBLY
1. Unpack the packing box and check the parts by referring to the part figure.
From the round base, loosen the 4 screws located in the center. (See Fig.1)
2. Set the column and align the screw holes. (See Fig.2)
3. Tighten the screws. (If you can't tighten, check the nuts on the bottom of the
round base.)
4. To attach the stand (cover for the base) unscrew the height adjustment ring
located on the top of the column, slide the ornament down the external pole
and reattach the height adjustment ring. (See Fig.3, Fig.4)
5. From the external pole, loosen the height adjustment ring and adjust the
internal pole to the desired height. Note: If you can't find the internal pole, it
slides inside the external pole. You can pull it out from the external pole.
(See Fig.5)
6. To attach the head unit to the column, loosen the thumb screw on the bottom
of the head unit.
7. Place the head unit on the column and tighten the thumb screw in alignment with
the groove on the internal pole.(See Fig.6)
Fig.1 Fig.2
Screw
Spring washer
Washer
Nut
Fig.3
Motherboard
Stand
Ornament
2
Round base
Fig.4 Fig.5
Oscillation knob
Speed
control
buttons
Fig.6
Mounting hole
Thumb screw
Annular
groove
LOOSE