Tensioning The V-Belts; Setting The Speed; Setting The Drilling Table; Setting The Drilling Depth - Parkside PTBM 500 Instrucciones De Utilización Y De Seguridad

Tensioning the V-belts

Q
j
Release the fixing screw
unit towards the back of the device and
24
tighten the fixing screw
note: There is an interlock switch
the drive / belt cover
be restarted if the drive / belt cover
erly closed.

Setting the speed

Q
Danger of injury!
Wear protective gloves!
j
Open the drive / belt cover
the fixing screw
11
the desired drive wheel pairs.
1
2
3
4
Drive
(spindle side)
The bench press drill has 9 different speeds. The
speed is set by simply repositioning the V-belts
revolutions per minute
Q 390 A - 4 W 620 B - 4
R 790 C - 4 T 820 A - 2
U 1680 C - 2 I 2030 B - 1
Example Q 390 A - 4
A means that the first V-belt is mounted in position
A. 4 means that the second V-belt is mounted in
position 4.
note: The middle drive wheel is supported on a
movable bearing and adjusts in position when you
set the speed.
j
Now tension the V-belts
section about "Tensioning the V-belts".
E-3470_Table_Drill_PTBM500_Content_LB5.indd 31
, press the motor
11
again.
11
inside
29
. The motor can only
6
is prop-
6
and unscrew
6
. Place the V-belts on
28
A
B
C
Middle drive Drive
(motor side)
28
E 650 A - 3
Y 1020 B - 3
O 2600 C - 1
:
as described in the
28

Setting the drilling table

Q
j
Unscrew the clamp bolt
ing table to the desired height, or swivel it
19
to the side, e.g. if you are working on a tall
workpiece which can be attached directly to
the base plate
18
j
You can also incline the drilling table
to 45° to the right or left. Unscrew the bolt
using a size 19 spanner and hold the drilling
table in the desired position. Tighten the bolt

Setting the drilling depth

Q
The depth stop with its scale
device to drill to an exact depth.
j
Release the clamp bolt
. Move the drilling table
19
clamped workpiece is just in contact with the
drill tip.
Set the drilling depth as follows.
j
Release the fixing screw
j
Turn the scale
12
until the desired drilling depth is indicated by
the arrow marking.
j
Tighten the fixing screw
.
note: The left side of the scale
ing depth. The right side of the scale
the remaining drill stroke.
Exchanging tools / Inserting
Q
the drill
WarnInG!
Always pull the mains plug out
of the socket before doing any work on the device.
This precaution is intended to prevent you from
unintentionally starting the device.
j
Swing up the guard
j
Release the jaws of the chuck
chuck key .
32
j
Remove the inserted drill bit.
j
Insert the drill bit and close the jaws of the
chuck using the chuck key
3
Ensure that the drill bit is centralised in the chuck.
Operation
and slide the drill-
16
.
by up
19
22
22
allows you set the
12
of the drilling table
16
until the
19
.
8
of the drilling depth setting
8 .
shows the drill-
12
indicates
12
.
5
using the
3
.
32
GB/MT
17.03.2008 16:23:04 Uhr
.
31