Clamping The Workpiece In The Vice; Switching The Bench Press Drill On And Off; Drilling; Drilling Different Materials / Some Examples - Parkside PTBM 500 Instrucciones De Utilización Y De Seguridad

Operation / Servicing and cleaning / Disposal
Clamping the workpiece in
Q
the vice
Turn the clamping bolt
the jaws . Place the workpiece between the jaws
14
and clamp it by turning the clamping bolt
14
clockwise.
note: The vice
can be used to clamp flat and
13
rectangular workpieces. The vice has only a limited
ability to clamp tubes.
Switching the bench press drill
Q
on and off
Switching on:
j
Press the ON switch
Switching off:
j
Press the OFF switch

Drilling

Q
Turn the handle / spindle guide
three drill lifting arms anticlockwise. The chuck
moves downwards. Turn the handle / spindle guide
until the drill bit has penetrated the workpiece to
the desired depth, see Fig. D.
After satisfactorily completing your drilling operation
return the handle / spindle guide
position by turning it the opposite direction.
note: You should anticipate some counterpressure
from the handle / spindle guide. If you let go of the
handle / spindle guide, it will quickly return to its
original position.
Drilling different materials /
Q
Some examples
Drilling metal:
j
Select a low speed for hard metal and / or
large diameter drill bits.
32 GB/MT
E-3470_Table_Drill_PTBM500_Content_LB5.indd 32
anticlockwise to open
21
21
.
2
.
1
using one of the
7
3
to its original
7
Drilling wood:
j
Wear a dust protection mask. Wood dusts are
hazardous to health.
Further application examples
Drilling ceramic tiles / plastics:
j
Use a low speed. Use a suitable drill bit with a
centre point tip.

Servicing and cleaning

Q
WarnInG!
Always pull the mains plug out
of the socket before doing any work on the device.
This precaution is intended to prevent you from
unintentionally starting the device.
j
Clean the device frequently. This should be done
immediately after you have finished using it.
j
Use a dry cloth to clean the outside of the
device - never use petrol, solvents or cleaners.
j
Remove swarf, dust and dirt with a vacuum
cleaner.
j
Lubricate moving parts regularly.
j
Ensure that no lubricant contaminates the
switches , , V-belts
1 2
25 , 26 , 27 .

Disposal

Q
The packaging is wholly composed of
environmentally-friendly materials that
can be disposed of at a local recycling
centre.
Do not dispose of electrical
power tools with the household
rubbish!
In accordance with European Directive 2002 / 96 / EC
(covering waste electrical and electronic equipment)
and its transposition into national legislation, worn
out electrical power tools must be collected separately
and taken for environmentally compatible recycling.
and drive wheels
28
17.03.2008 16:23:04 Uhr