Pentair Pentek Solar Drive Specifications - Pentair PENTEK PSD30 Manual De Instalación Y Funcionamiento

PENTAIR PENTEK
Input Specification:
- Dual Solar PV Array Input
- Maximum Solar Open Circuit Voltage:
- Maximum Solar PV Current in Series:
- Earth-ground connected to chassis
ˆDC PV input terminals shall only be connected to listed photovoltaic modules and panels that
comply with UL 1703.
ˆˆSuitable for use on a circuit capable of delivering not more than 27 rms symmetrical amperes,
400 volts maximum.
Output Specification:
- Maximum Output Current:
- Maximum Output Current:
- Maximum Power Sustained:
Protections:
- Short-circuit, ground-fault, over-temperature, overload, over-voltage,
over-current, and solar input reverse polarity protection
- Automatic dry well protection and pump locked rotor protection
Integral solid state short circuit protection does not provide branch circuit protection. Branch
circuit protection must be provided in accordance with the National Electrical Code and any
additional local codes.
ELECTRICAL
Solar PV open circuit voltage: 400Vˆ
Max PV panel current in series: 9A
Max Single phase AC motor current: 13A
Max Three phase AC motor current: 10.5A
ˆPer solar array
Carefully check the motor load specifications and solar PV array maximum power point
voltage to set up the system properly using this manual!
P1062 (06/06/19)
SOLAR DRIVE SPECIFICATIONS
*
400 Vdcˆ
9 Amps per solar arrayˆˆ
13 Arms (1-phase motors)
10.5 Arms (3-phase motors)
3500 W
Degree of protection: TYPE 3R
Enclosure material: Aluminum
Operating temperature: -40˚C to 40˚C
AC Source Terminals: AWG #10-16
Solar Terminals: AWG #10-16
Motor terminal: AWG #8-16
Float Sensor terminals: AWG #14-20
WARNING:
MECHANICAL
Dimensions: 18"x10"x5"
5