Pentair PENTEK PSD30 Manual De Instalación Y Funcionamiento página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PENTAIR PENTEK
The features of a Pentair Pentek Solar Drive' s printed circuit board are shown in Figure 7. The
installer needs access to these features when configuring the Pentair Pentek Solar Drive' s DIP
switches to match the AC motor load (described in greater detail on pages 11-12).
Terminal
for Motor
ON/OFF Switch
50Hz
Single Phase
120Vac
ON
230Vac
Three Phase
60Hz
Figure 7: Pentair Pentek Solar Drive Printed Circuit Board Features Overview
Do not modify DIP switch settings until power has been turned off and after 90 seconds have
passed for internal voltages to discharge below voltage of 50Vdc! Power must be removed for
DIP switch settings to take effect.
P1062 (06/06/19)
SOLAR DRIVE OVERVIEW
*
Float Switches and
DIP Switches
Minimum Motor
Frequency
1
2 3 4 5 6 7 8 9 10 11 12
Overload
Protection
Sensors
1-Phase, 3-Wire Enabled
Max Frequency
Unused
Flow Switch
1-Phase, 3-Wire Disabled
WARNING
DIP Switch
ON
DIP Switch
OFF
9

Publicidad

Tabla de contenido
loading

Tabla de contenido