Optoma OWM3000 Manual De Usuario página 3

Safety
Read these instructions carefully before installing your equipment
Install the mount in suitable location using fixings which are appropriate for the wall material
and structure
Consult a qualified builder if you are in any doubt as to the structural integrity of the wall
Use all available fixing points
DO NOT attempt to alter or modify any part of the wall mount or its attachements
DO NOT use if any parts are broken or appear to be damaged.
Tighten all bolts and fixings securely
Only use fixing provided with this bracket
DO NOT mount your projector near to sources of heat of moisture
Always have minimum of two persons to install the projector and the mount
Wall Plate x 1
Step 1: Attach the wall plate to the wall
● The bracket is suitable for concrete wall mounting or wooden stud wall or calcium silicate board.
● For concrete wall mounting, thickness of the wall must be not less than 4'' (100mm). Anchor bolt and
screw (M6x55) are needed to be used for concrete wall installation.
● For wood stud wall mounting, the minimum size of the wall should not be less than 20x12 inch. The
thickness of the wall must be not less than 3" (76.2mm).If there is a gypsum board on the surface of
wood stud wall, the thickness of gypsum board should not be bigger than 3/8 inch .Only screw (M6x55)
is needed to be used for the installation
2
Projector Mounting
Plate x 1
Wall Cover x 1
Wall Plate Cover x 1
Mounting arms x 4
.
Fixing Kit
Screw(M6x55)
10mm Anchor Bolt
L5 Allen Wrench
L3 Allen Wrench
Screw(M4x8)
Screw(M6x15)
Connecting Screw M4
Screw(M3x10)
Screw(M5x12)
Screw(M5x25)
Nut M5
Plastic Spacer (8.0)