Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
●Forcalcium silicate board mounting, screws M6x55 must be attached to the stud and securely fastened.
Note: If the thickness of wall is not strong enough, reinforce it sufficiently before installation.
≥ 100mm
≥ 55mm
Ø10-11mm
Concrete wall mounting
The arrows up
Screw M6x55 and anchor bolts are
needed for concrete wall mounting.
●Insert screwA(M6x55)fromthefixingkit,tightenwithaL5Allen Wrenchfromfixingkit.
Step 2: Attach the projector mount to the wall plate
The cables
Loosen the screws with L3 Allen Wrench,
pull out the telescopic arm arond
and make power cable & signal cables go
through the telescopic arm.
● Insert Screw F(M6x15) from the fixing kit, tighten with a L5 Allen Wrench from fixing kit.
With anchor bolt
A
C
The arrows up
D
4'' (100mm)
B
Ø3mm
Wood stud mounting
For wood stud or calcium
silicate board mounting,
screws M6x55 must be
attached onto the center of
stud and securely fastened.
These four screws must be
fastened on the stud
Only screw (M6x55) i s needed for wood
stud wall or calcium silicate board mounting.
The cables
The cables can go through the wall plate
by three ways as shown in the pictures. Then,
tighten the screw F after locating the projector
position.
≥ 114mm
≥ 55mm
Without anchor bolt
A
C
Or
The arrows up
These two screws must
b e fastened on the stud
A
C
The cables
3
Publicidad
Tabla de contenido
